Concrete Leveling & Slab Lifting in Frisco, TX
From Starwood to Phillips Creek Ranch, we lift sunken concrete back to grade with foam injection — no tear-out and same-day use.
Frisco grew fast, and much of that growth happened on graded pads and imported fill dirt spread across expansive Blackland Prairie clay. When that fill was not fully compacted, or when the underlying clay swells and shrinks with our wet-then-dry seasons, slabs settle. It is one of the most common calls we get from newer Frisco communities like Richwoods and Westfalls Village, where a driveway or patio poured just a few years ago has already dropped at one corner.
Concrete leveling solves that without the mess of replacement. We drill a handful of dime-sized ports through the sunken slab and inject expanding polyurethane foam underneath. The foam spreads into the voids left by settled fill, compacts the soil, and raises the concrete precisely back to grade. There is no demolition, no new forms, and no days of curing — the foam sets in minutes and the surface is ready to use right away.
Because leveling costs roughly 30 to 50 percent of a full replacement and most jobs finish in a few hours, it is an easy decision for Frisco homeowners protecting newer, high-value properties. Whether it is a pool deck that has settled near Stonebriar or a garage floor that has dropped in Starwood, we can usually bring it back to level in a single visit.
Why Choose Dallas Concrete Pros for Concrete Leveling in Frisco?
Frisco is fill-dirt country, and we have leveled countless slabs across its master-planned neighborhoods, so we know exactly how settlement shows up here — corners dropping on driveways poured over compacted pads, patios pulling away from the house, walkways heaving and dipping. We use polyurethane foam instead of heavy mudjacking because it is lightweight and waterproof, which matters on Frisco clay. Every project starts with an honest assessment, comes with clear pricing, and is backed by a workmanship warranty.
- Corrects settlement over uncompacted Frisco fill without replacement
- Costs about 30 to 50 percent of a full concrete tear-out and pour
- Waterproof foam that resists washout in expansive clay soil
- Lightweight polyurethane is gentler on graded pads than mudjacking
- Most residential slabs lifted in just a few hours
- Same-day use — foam cures in minutes after injection
Our Concrete Leveling Process in Frisco
On-site assessment
We measure the amount of settlement, inspect drainage and fill conditions, and confirm the slab is sound enough to lift rather than replace.
Mark and drill ports
We locate the voids beneath the panel and drill small, dime-sized injection ports spaced to raise the concrete evenly.
Foam injection
Expanding polyurethane foam is pumped under the slab, filling the gaps left by uncompacted fill and compacting the soil as it expands.
Precision lift to grade
We watch the slab rise in real time and control the flow so the concrete stops exactly level with the surrounding surface.
Patch and seal ports
The injection ports are filled with fresh concrete and smoothed so they blend into the finished surface.
Cleanup and walkthrough
We tidy the site and review the finished lift with you. The foam cures within minutes, so the slab is ready for same-day use.
Concrete Leveling Across Frisco Neighborhoods
We serve concrete leveling throughout Frisco, from the luxury estates of Starwood and Phillips Creek Ranch to the newer rooftops of Richwoods, Edgewood, and Westfalls Village. Homes built on graded fill near the fast-developing corridors around Frisco Square and Stonebriar Centre are especially prone to corner settlement, and pool decks and patios in these communities are frequent candidates for foam lifting. Wherever your slab has dropped, we tailor the lift to how your lot was built.
Concrete Leveling Cost in Frisco, TX
Concrete leveling in Frisco generally runs between $600 and $2,000, depending on square footage, the height of lift required, and how the void is accessed. A single sunken driveway panel or short walkway sits at the lower end, while larger pool decks and patios run higher. We provide a free on-site assessment with firm numbers — call Dallas Concrete Pros at 214-466-2536 to schedule.
Get an accurate quote for your project
Every property is different. Contact us for a free on-site estimate tailored to your Frisco property.
Request Free EstimateConcrete Leveling in Frisco — Frequently Asked Questions
My Frisco home is new — why is the concrete already sinking?
Newer Frisco neighborhoods are often built on imported fill dirt over Blackland Prairie clay. If that fill was not fully compacted, or the clay swells and shrinks with the seasons, slabs settle within a few years. Foam injection fills the resulting voids and lifts the concrete back to grade.
Will foam leveling work on my pool deck?
Yes. Pool decks are one of the most common slabs we lift in Frisco. We inject foam beneath the settled sections and raise them precisely back to level, and because the foam is waterproof it holds up well around pools.
How is this different from replacing the slab?
Replacement means demolishing your concrete, hauling it off, and pouring new slabs that take days to cure. Leveling keeps your existing concrete, lifts it in a few hours with foam, and costs roughly 30 to 50 percent as much.
Can I drive on my driveway right after leveling?
In almost every case, yes. The polyurethane foam reaches full strength within minutes, so most Frisco driveways can be driven on the same day the work is completed.
What does concrete leveling cost in Frisco?
Most residential jobs fall between $600 and $2,000 depending on area, lift height, and access. That is a fraction of replacement cost. Call 214-466-2536 for a free on-site estimate.
Concrete Leveling in Other Cities
Ready for Concrete Leveling in Frisco?
Get a free, no-obligation estimate for your Frisco property today.