Dallas Concrete Pros

Concrete Leveling & Slab Lifting in Irving, TX

From Las Colinas high-rises to Valley Ranch cul-de-sacs, we raise sunken driveways, patios, and walkways back to grade without tearing anything out.

Concrete Leveling in Irving, TX by Dallas Concrete Pros

Irving sits on the same expansive Blackland Prairie clay that runs beneath the entire DFW metroplex, and that soil is the number-one reason concrete slabs go uneven here. When the clay soaks up water it swells, and when a Texas drought bakes it dry it shrinks and pulls away from whatever it was supporting. Over a few seasons that constant movement, combined with eroded builder fill and the occasional plumbing leak, leaves driveway panels, patios, and garage floors sitting low and out of level. At Dallas Concrete Pros we lift that concrete back to where it belongs instead of ripping it out.

Our method is modern polyurethane foam injection, not the heavy mudjacking of decades past. We drill a series of dime-sized ports through the slab, inject an expanding structural foam that flows into the voids beneath, compacts the loose soil, and raises the concrete precisely to grade. The foam is waterproof and lightweight, so it will not add weight that overloads Irving's already shifting clay, and it cures within minutes. Most homeowners are parking on the surface the same day.

For Irving properties this is usually the smart call. Whether it is a settled walkway outside a South Irving bungalow or an uneven pool deck in Valley Ranch, leveling runs roughly 30 to 50 percent of what full replacement would cost, and most residential jobs wrap up in a few hours rather than the days a tear-out and repour demand.

Why Choose Dallas Concrete Pros for Concrete Leveling in Irving?

We have worked concrete across every part of Irving, from the corporate campuses of the Las Colinas Urban Center to the older streets near the Heritage District, so we know how this city's soil behaves block by block. We diagnose why a slab sank before we lift it, give you honest guidance on whether leveling or replacement makes more sense, and back the work with a written warranty. Every quote is transparent, every port is patched clean, and your project is handled by a crew that lives right here in the DFW area.

  • Lifts sunken driveways, patios, and walkways without demolition or a repour
  • Costs roughly 30 to 50 percent of full concrete replacement
  • Waterproof foam will not wash out of Irving's expansive clay
  • Lightweight foam avoids overloading soil the way old mudjacking did
  • Most residential jobs finished in a few hours with same-day use
  • Eliminates trip hazards and pooling water around your foundation

Our Concrete Leveling Process in Irving

1

Free on-site assessment

We measure the drop, probe the soil around the slab, and identify what caused the settling — clay movement, washed-out fill, or a drainage problem — before recommending a fix.

2

Written leveling plan

You get a clear quote showing the area to be lifted, the target grade, and the number of injection ports, with no vague allowances or surprise add-ons.

3

Drill injection ports

We drill small dime-sized holes through the slab in a pattern designed to distribute the lift evenly across the sunken section.

4

Inject structural foam

Expanding polyurethane foam is pumped through the ports, filling voids and compacting the soil until the slab rises smoothly and precisely back to grade.

5

Verify level and patch

We confirm the slab sits true with a level, then fill the ports with color-matched cement so the repair is barely noticeable.

6

Same-day walkthrough

The foam cures in minutes, so we walk the finished surface with you and, in most cases, you can drive or walk on it right away.

Concrete Leveling Across Irving Neighborhoods

We level concrete throughout Irving, from the sleek plazas and townhomes around the Las Colinas Urban Center and Toyota Music Factory to the family streets of Valley Ranch and the mature lots of South Irving. Homes along the MacArthur Boulevard corridor and in the Heritage District tend to be older, with driveways and walkways that have settled over decades, while newer builds near the Campión Trail often show early settling as builder fill compacts. Wherever your slab has dropped, we adjust our port spacing and foam volume to the age of the concrete and the soil under it.

Las ColinasValley RanchSouth IrvingMacArthur Blvd areaHeritage District

Concrete Leveling Cost in Irving, TX

Most residential concrete leveling in Irving runs between $600 and $2,000 depending on the square footage and how much lift the slab needs. A single settled driveway panel or a short walkway sits at the lower end, while a full patio or garage floor lands higher. That is typically 30 to 50 percent of what replacement would cost. Call Dallas Concrete Pros at 214-466-2536 for a free on-site assessment and exact pricing.

Get an accurate quote for your project

Every property is different. Contact us for a free on-site estimate tailored to your Irving property.

Request Free Estimate

Concrete Leveling in Irving — Frequently Asked Questions

How long does foam concrete leveling last in Irving?

The polyurethane foam itself is inert and does not break down, so the lift is permanent as long as the underlying soil stays stable. Because Irving sits on expansive clay, we also look at drainage during the assessment so water is not repeatedly washing out the soil beneath your slab.

Is leveling really cheaper than replacing my driveway?

In most cases, yes. Leveling typically costs 30 to 50 percent of a full tear-out and repour because there is no demolition, no hauling, and no new concrete to buy and cure. If your slab is structurally cracked apart rather than simply sunken, we will tell you honestly when replacement is the better value.

Can I use my driveway the same day?

Usually. The structural foam reaches its working strength within minutes of injection, so most Irving homeowners can walk on or drive over the leveled surface the same day, unlike a repour that needs days to cure.

Why did my Las Colinas patio sink in the first place?

The most common cause here is our expansive clay swelling and shrinking with wet and dry cycles, which leaves voids under the slab. Poor drainage, eroded builder fill, and plumbing leaks that wash out supporting soil also contribute. We identify the specific cause so the fix holds.

Will the injection holes be visible in my concrete?

Only faintly. The ports are about the size of a dime, and we patch each one with cement matched to your slab color. On a weathered driveway or patio the patches blend in quickly and are easy to overlook.

Ready for Concrete Leveling in Irving?

Get a free, no-obligation estimate for your Irving property today.